FAQ

Dust, oil and coating residue can affect splice quality and cause avoidable signal loss. Clean the stripped fiber and relevant connector or tool surfaces with appropriate lint-free materials before cleaving and fusion splicing.

A consistent preparation routine—strip, clean, cleave and splice—helps field teams work more reliably. Replace worn consumables and keep tools protected when not in use.

Read full answer →

After installation, verify that the fiber link meets the project requirements for continuity, loss and connector quality. The exact process depends on the network specification and the equipment used.

Typical checks

• Inspect and clean connector endfaces before testing
• Use an appropriate optical test method to confirm link condition
• Use an OTDR where event analysis or fault-location information is needed
• Record results for installation acceptance and future maintenance

For a practical tool combination covering preparation, splicing and testing, contact VAEYI with your fiber type and project application.

Read full answer →

Clean, protected and correctly maintained fiber tools help support repeatable field work and reduce avoidable preparation errors.

Good maintenance practice

• Keep cleaver surfaces and collection bins clean according to the product instructions.
• Store strippers, cleavers and testing instruments in protective cases between jobs.
• Inspect blades, electrodes and other consumable parts at the recommended intervals.
• Use approved cleaning materials for fiber endfaces and tool-contact areas.
• Confirm battery condition and charging arrangements before field deployment.

Refer to the equipment documentation for model-specific procedures. Contact VAEYI for spare parts, accessories or product-selection guidance.

Read full answer →